Analysis of the cause of poor forming of wood pellet machine

When you use the wood pellet machine, have you encountered a granular formation bad? How should we solve it? Today, we will analyze it:

First, the length of the granules is different, the distance between the wood chips particle machine should be adjusted or adjusted the split mitigation scraping position;
Second, the surface of the particles is smooth, but the particles are too hard. It may be because the compression of the wood chips granular machine loop is relatively small, and the compression hole should be increased.
Third, the surface surface is not very smooth, and the powderization rate is high. It may be that the compression of the wood chips granular loop molding is relatively small, and the compression hole should be increased.
Fourth, when the particle water is high, the production output is low, and the phenomenon of blocking is often occurred. It can increase the quality of the wood chips granular machine accordingly. The increase in temperature is conducive to the improvement of material maturity;
Fifth, there are axial cracks or radial cracks, and the powder is high, and the output is low. It may be that the position of the wood chips particle machine is far and blunt, making the particles be touched or torn instead of cutting.
Finally, please pay attention to the usual equipment maintenance. During the production process, the equipment needs to be cleaned up to avoid hard particles such as large pieces of sand, sand grains, iron blocks, bolts, and iron chips. Because these will accelerate the wear of the ring mold, and a large, large and hard mixed mix will cause multiple shots of the ring mold, which will cause the ring mold to fatigue. When a certain force exceeds the strength limit of the ring mold, the machine will fail.
If the granules are poorly molded, it is necessary to correct it. We have 20 years of manufacturing experience in wood pellet machine manufacturing. If you have any questions, please consult. We can provide tailor -made solutions based on your raw materials, venues, and uses.


Post time: Oct-10-2022